Soft Touch Cushioned Bath Fixtures
For the Physically Challengedby Diversified Fiberglass Fabricators, Inc.
Soft Touch Cushioned Bath Fixtures
For the Physically Challenged
by Diversified Fiberglass Fabricators,
Inc.
Roll-in Showers Designed for Special Needs.
DFF roll-in showers are specially designed to meet the needs
of people with physical limitations - at home or in medical centers. These
fixtures were developed to make bathing easier and safer for paraplegics,
hemiplegics, and other people with disabilities who need to shower from
a shower wheelchair. These showers may also be used as conventional showers
by people who wish to stand and shower. This dual function works well with
elderly or disabled people who live with a family where all family members
must use the same bathing fixture.
The showers are perfect for retrofit situations, because they are shipped in two sections which can pass through existing doorways (32" typical for wheelchair access). The showers can be recessed into the floor for level access or installed above the floor to be accessible with a ramp. The showers are constructed of fiberglass reinforced plastics for durability and long use.
Roll-in Showers for Independent Bathing.
Model # 5560
This full-height shower is intended for people who shower from a shower wheelchair independently.
Shower Curtain:
The front curtain is mounted on the ceiling and can be installed with
manual controls. The curtain is raised and lowered by pulling on a beaded
cord located inside and outside the shower. An optional shower curtain
mounted around the other three sides of the shower is also available.
Dimensions:
Length - Inside 50 3/4", Outside 55 1/2"
Width - Inside 31 3/4", Outside 37 1/2"
Height - 59"
Roll-in Shower for Assisted Bathing.
Model # 5530
This half-height shower is designed for users who need assistance
in taking a shower.
Shower Curtain:
This shower uses two curtains. One is mounted at the entrance of the
shower, the other is mounted around the other three sides of the shower.
The side curtain has two openings so that an attendant can assist in bathing
without getting wet. The front curtain is mounted on the ceiling and can
be installed with manual control. The curtain is raised and lowered by
pulling a beaded cord located inside and outside the shower.
Dimensions:
Length - Inside 50 3/4", Outside 55 1/2"
Width - Inside 31 3/4", Outside 37 1/2"
Height - 30 1/2"
Standard Equipment:
(Full-Height and Half-Height Showers)
Fibergalss shower, ceiling mounted curtain(s), Hand-held hose spray, wall
bracket, Touch 'N Flo valve set, thermostatic valve, plastic flex floor
mat.
Water/Temperature Control:
A push button valve is used to turn the water on and off. Water flows
for up to two minutes and turns off automatically. The water temperature
is controlled by a thermostatic valve mounted on the outside of the shower.
Water temperature is preset when the shower is installed and, if necessary,
can be adjusted from outside the shower. A hand-held shower is mounted
on the left at a height that is most convenient for the user.
NOTE: These shower systems are designed for specialized applications not
generally covered by ANSI or UFAS codes (e.g., residences), Be sure to
check codes for compliance.
Wall-Mounted Shower Seat - Model # 3224-WM
* Veterans Administration Approved
The shower seat is designed for people who can transfer from a wheelchair
with or without assistance and who can maintain a stable seated position
during bathing. The back rest and seat area provide full support and prevent
the user from sliding. The wide seat area also allows for easy transfer
from a wheelchair. The seat is constructed of fiberglass reinforced plastics
and the Soft Touch.
Home | Tubs | More Information
Page Design By: Web Results
E-Mail:rfarns@vnet.net
Last Updated: May 20, 1996
©copyright 1997 Web Results